Operating Notes - Impex Marcy Pro NS-6023RW Assembly & Owners Manual

OPERATING NOTES

FILLING AND EMPTYING THE WATER TANK
1. Remove the Tank Fill Plug (No.50) from the Upper Tank Cover (No. 24).
2. To fill the tank with water, refer to Fig. A.
• Insert the Funnel (No. 52) into the tank, then use a cup or the Siphon Pump (No. 53) and
a bucket to fill the tank. Use the water level indicator on the side of the tank to fill to the
desired water level in the tank.
3. To empty the tank, refer to Fig. B.
• Place a bucket next to the rower and use the Siphon Pump (No. 53) to pump out the water
from the tank into the bucket.
4. Re-insert the Fill Plug (No. 50) into the Upper Tank Cover (No. 24) when done. Wipe off excess
water from the frame.
NOTE:
• Fill the tank only with tap water. Never use pool chlorine or chlorine bleach, this will damage the
tank and void the warranty.
• Do not consume the tank water. Dispose the water after pumping it out from the tank.
WATER LEVEL
• See Fig. A. The water level indicator is on the side of the tank. The maximum fill level is 6.
Never fill it over this limit. Filling the tank over this limit will void the warranty.
• The resistance depends on the water level in the tank. Water level 1 is the lowest resistance. Level
6 is the highest resistance.
52
53
24
© IMPEX INC.
Fig. A
50
Water level label
14
53
50
24
www.marcypro.com
Fig. B