Table of Contents
Advertisement
OPERATING NOTES
1. Remove the Fill Plug (No.25) from the Upper Tank Cover (No.17).
2. To fill tank with water, refer to Fig. A. Insert the Funnel (No.73) into the tank, then use a cup or
the Siphon Pump (No.74) and a bucket to fill the tank. Use the water level gauge on the side of
the tank to measure desired water level in the tank.
3. To empty the tank, refer to Fig. B. Place a bucket next to the rower, and use the Siphon Pump
(No.74) to pump out the water from the tank into the bucket.
4. Insert the Fill Plug (No.25) into the Upper Tank Cover (No.17). Wipe excess water off of the
frame.
NOTE
:
• Fill the tank only with tap water. Add 1 water-purification tablet (1 packet is included.). Never use
pool chlorine or chlorine bleach. This will damage the tank and void the warranty.
• Add a water purification tablet every 6 months or as needed. If water remains cloudy, replace
the water in the tank.
• Water from the tank is not suitable for consumption. Dispose the water after pumping it out from
the tank.
A.WATER LEVEL
• See Fig. A. The water level gauge is on the side of the tank. The maximum fill level is 6. Never
fill it over this limit. Filling the tank over this limit will void the warranty.
• The resistance depends on the water level in the tank. Water level 1 is the lowest resistance.
Level 6 is the highest resistance.
25
73
74
© IMPEX INC.
Fig.A
17
Water level label
14
25
74
www.marcypro.com
Fig.B
17
Advertisement
Table of Contents
