Table of Contents
Advertisement
WARNING. Always wear safety glasses
and keep guard in place when grinding.
Hot metal sparks from metal grinding can cause a
fire. Avoid spark contact with flammable materials
such as saw dust or clothing.
Grinding wheels must be free of fissures and
cracks. Fissures and cracks can cause a grinding
wheel to shatter resulting in possible serious injury.
Thoroughly inspect a new grinding wheel before it
is installed on the grinder.
1. Use a wooden hammer for the inspection.
2. Using the hammer, lightly tap all around the
wheel, carefully listening to the resulting
sounds.
3. Any places with fissures or cracks will result in
a different sound. Do not use a wheel
containing fissures or cracks. When installing a
new grinding wheel, a no load revolution test of
approximately one minute must be carried out
with the grinding wheel facing a safe direction,
i.e. away from people or objects.
DANGER. Never attach a wood cutting
or carving blade of any type to this angle
grinder. It is only designed for grinding
metal. Use for any other purpose is not
recommended and creates a hazard
which will result in serious injury.
WARNING. Do not allow familiarity with
products to make you careless.
Remember that a careless fraction of a
second is sufficient to inflict injury.
WARNING. Always wear eye protection
with side shields marked to comply with
ANSI Z87.1. Failure to do so could result
in objects being thrown into your eyes,
resulting in possible serious injury.
CONNECTING TO A POWER SUPPLY
Make sure the on/off switch is in its off position.
Connect the plug with a suitable socket.
WARNING. Check the voltage!
The voltage must comply with the
information on the rating label.
CAUTION. Never cover air vents. They
must always be open for proper motor
cooling.
OPERATION
ON/OFF TRIGGER
To switch on the unit, press forward the safety lock
and then press the on/off trigger, Fig.6.
To switch off the unit, release the on/off trigger.
ADJUSTING THE ROTATING HANDLE
POSITION
Turn off the tool. Press and hold the handle lock
button, Fig.7, then turn the rotating handle to the
desired position until it snaps in place.
GRINDING
Always carefully select and use grinding wheels
that are recommended for the material to be
ground. Make sure that the minimum operating
speed of the grinding wheel selected is not less
than 6,500rpm.
The correct grinding wheel should be suitable for
grinding welds, preparing surfaces to be welded,
grinding structural steel, and grinding stainless
steel.
10
ON/OFF TRIGGER
SAFETY LOCK
Fig. 6
HANDLE LOCK
BUTTON
Fig. 7
WARNING. Do not adjust the rotating
handle while the tool is in operation.
Advertisement
Table of Contents
