6: Adjusting The Speaker Levels And Balance; Test Tone - Sony HT-SF800M Operating Instructions Manual

x PL. XXXX
SR
SL
(Surround speaker placement)
Lets you specify the height of your surround speakers
for proper implementation of the surround effects of
the Cinema Studio EX modes (page 24).
B
A
• LOW
Select if the height of your surround speakers
corresponds to section A.
• HIGH
Select if the height of your surround speakers
corresponds to section B.
GB
16
B
60
A
30
6: Adjusting the speaker
levels and balance

— TEST TONE

Adjust the speaker levels and balance while
listening to the test tone from your listening
position.
Tip
The receiver employs a test tone with a frequency
centered at 800 Hz.
1
Press ?/1 to turn on the receiver.
2
Press TEST TONE.
"T. TONE" appears in the display and the
test tone is output from each speaker in
sequence.
Front (left) t Center t Front (right) t
Surround (right) t Surround (left) t
Subwoofer
3
Adjust the speaker levels and balance
using the LEVEL menu so that the level
of the test tone sounds the same from
each speaker.
For details on the LEVEL menu settings,
see page 26.
Tips
• To adjust the level of all speakers at the same
time, press MASTER VOL +/– on the remote or
turn MASTER VOLUME on the receiver.
• The adjusted value are shown in the display
during adjustment.
4
Press TEST TONE again after
adjustment.
The test tone turns off.