Download Print this page
Bionaire BCM658 Instruction Leaflet

Bionaire BCM658 Instruction Leaflet

Digital cool mist humidifier with permanent filter

Advertisement

BCM658_08EM1.qxd:BCM658_08EM1.qxd
5/29/08
8:56 AM
Page 1
FILTER WASHING PROCEDURE
5. Put filter back in, replace the housing, then refill
reservoir with cool tap water as instructed earlier in
1. The water tray should be cleaned when you clean the
the Filling Instructions. Do not overfill.
filter. The water tray is a convenient way to carry the
filter to prevent dripping.
6. Follow Operating Instructions.
2. Mix 1 gallon warm tap water with 1 teaspoon
concentrated antibacterial liquid dish washing soap.
WEEKLY MAINTENANCE
To Remove Scale:
3. Fully submerge filter in soap solution for 15-20 minutes.
1. Repeat steps 1-4 in the Daily Maintenance section.
4. Dunk filter in soap solution several times then gently
press to release the soapy water. Be sure not to
2. Clean the base by partially filling the base with one 8-
wring, pull or scrub filter as this will degrade the filter.
oz cup of undiluted white vinegar, or by using Clean
Away
5. Run under cool tap water until there is no soap
this solution in the base for 20 minutes, while cleaning
remaining. Some discoloration may still be visible, this
all the interior surfaces with a soft brush. Remove
is normal and does not affect performance.
base scale by wiping the base with a cloth dampened
6. Gently shake or press the filter to remove excess water.
with undiluted white vinegar.
7. The filter can be put directly into the humidifier while
3. Rinse with clean warm water to remove the cleaning
still damp if it is to be used right away, or allow filter to
solution before disinfecting the reservoir.
dry completely if humidifier is to be stored.
Should your filter become damaged or lost, please call
TO DISINFECT RESERVOIR
the customer service number listed in the manual for a
1. Fill humidifier reservoir 1/2 full with water and 1/2
replacement part. The part number for this filter is:
tablespoon of chlorine bleach.
BWF100P/HWF100P.
2. Let the solution stand for 20 minutes, swishing every
few minutes. Wet all surfaces.
CLEANING AND MAINTENANCE INSTRUCTIONS
3. Carefully empty the reservoir after 20 minutes, and
Humidifiers provide comfort by adding moisture to dry,
rinse with warm water until you can not detect any
heated indoor air. To benefit most from the humidifier and
bleach smell. Dry with a clean cloth or paper towel.
avoid product misuse, follow all instructions carefully.
Please note that this is an electrical appliance and
4. Place filter back into reservoir and refill the water
requires attention when in use.
reservoir as directed in Operating Instructions, and
turn the unit on.
In addition, if you do not follow the recommended care
and maintenance guidelines, micro-organisms may be
able to grow in the water within the water reservoir. You
STORAGE INSTRUCTIONS
must routinely follow the cleaning procedures that follow
If your humidifier will not be in use for two days or more,
in order to ensure proper, efficient operation of your
or at the end of the season follow these instructions.
humidifier. Proper maintenance and cleaning is essential
1. Clean and dry the humidifier thoroughly as per the
to the continued performance of your unit and the
"Weekly Maintenance" instructions.
avoidance of algae or bacteria build-up.
2. Let the humidifier dry completely before storing. Do
not store with water inside the base or water reservoir.
DAILY MAINTENANCE
3. Remove the reservoir cap. Do not store with the
1. Be sure the unit is OFF and is disconnected from the
reservoir cap in place.
electrical outlet.
2. Remove the housing and the reservoir from the
4. Follow Filter Washing Procedure before storage.
humidifier and place in sink or tub.
Ensure that the filter is completely dry before being
stored.
3. Carry the base of the unit to the sink, remove the wick
5. Store in a cool dry location.
place in sink, drain any remaining water and rinse
thoroughly to remove any sediment or dirt. Wipe
clean, and dry with a clean cloth or paper towel.
4. Drain the water from the reservoir into the sink and
rinse reservoir thoroughly. Wipe clean, and dry with a
clean cloth or paper towel.
Trouble
☛ Not plugged in.
• Unit does not turn on.
☛ Filter has not
• Mist output minimal to none.
• Filter turns brown.
☛ The filter has absorbed
☛ Takes 60 minutes to register.
• FilterClean
TM
is not working.
TM
(Model DMS216) by the manufacturer. Leave
• Humidifier continuously
☛ Humidity at the humidifier is
displays 21%.
• Humidifier continuously
☛ Humidity at the humidifier is
displays 90%.
Frequently Asked Questions
Question
☛ The estimated run time for this humidifier is based on aveage
• What are the variables that
affect run time?
☛ See Daily Maintenance instructions. Regular cleaning is
• How do I remove film on
water tank?
☛ Run your unit on the lowest setting.
• How can I extend the run
☛ If your unit has electronics, set it to your desired humidity
time?
☛ Fill the reservoir all the way full, place it on the base, let the
1 YEAR LIMITED WARRANTY
Troubleshooting
Probable Cause
Solution
✔ Plug in unit.
✔ Wait 30 minutes for filter
absorbed water.
to absorb water.
✔ Wash your wick filter
minerals.
(BWF100P/HWF100P).
Follow the Filter Washing
Procedure located on this
manual.
✔ Allow the humidifier to run
continuously for 60 minutes
for the FilterClean
TM
Indicator to reflect the filter
condition.
✔ Continue to operate
humidifier to raise the room
at or below 21%.
humidity.
✔ Stop operating the
humidifier if the humidity
at or above 90%.
level is too high.
Answer
room conditions. The actual run time of your humidifier
is dependent on numerous variables such as:
1. Air exchange in the room where the humidifier is
placed.
2. Room construction of the room where the humidifier is
placed.
3. Temperature of the room where the humidifier is
placed.
What are the limits on JCS's Liability?
4. Humidity levels in the room where the humidifier is
placed.
5. Movement of occupants and the opening and closing of
doors in the room where the humidifier is placed.
6. Home furnishings in the room where the humidifier is
placed.
recommended.
level. The unit will turn on and off, which will extend the run
time.
water empty into the base until it stops bubbling, then refill
the reservoir full again. This ensures maximum water
capacity and will extend run time.
How to Obtain Warranty Service
PLEASE DO NOT RETURN THIS PRODUCT TO ANY
OF THESE ADDRESSES OR TO THE PLACE OF
PURCHASE.
If after having read this leaflet, you have any
BCM65808EM1
Printed in China
Digital cool mist
humidifier
with permanent filter
BCM658
MODEL
FILTER# BWF100P/HWF100P (2)
Filter Type: Permanent Wick
Read instructions before operating.
Retain for future reference.
Instruction Leaflet
INFO-LINE
questions or comments on your humidifier,
call 1-800-253-2764 in North America.
127056/9100030004882

Advertisement

loading

Summary of Contents for Bionaire BCM658

  • Page 1 STORAGE INSTRUCTIONS must routinely follow the cleaning procedures that follow If your humidifier will not be in use for two days or more, in order to ensure proper, efficient operation of your or at the end of the season follow these instructions.
  • Page 2: Filling The Water Reservoir

    The Digital Humidistat allows the user to program the When the needle is in the Wash Filter section, this means humidifier to come on at a preset time, or turn off after a the proper amount of moisture is not getting into your air set amount of time.

This manual is also suitable for:

Sa861-80