Sony 4-130-031-11(3) Operating Instructions Manual page 58

6
Press V/v repeatedly to select
the setting you want, then
press .
• RF AUTO: Normally select this. The
system change "RF CHNG" to "RF
ON" or "RF OFF" automatically.
• RF ON: The system transmits sound by
searching the better channel for
transmitting.
• RF OFF: The system transmits sound by
fixing the channel for transmitting.
To exit the menu
Press AMP MENU.
Notes
• When the wireless transmitter is not inserted in the
S-AIR main unit, you cannot set "RF CHNG".
• In most cases, you will not need to change this
setting.
• If "RF CHNG" is set to "RF OFF," transmission
between the S-AIR main unit and S-AIR sub unit
can be performed using one of the following
channels.
– S-AIR ID A: equivalent channel for IEEE
802.11b/g channel 1
– S-AIR ID B: equivalent channel for IEEE
802.11b/g channel 6
– S-AIR ID C: equivalent channel for IEEE
802.11b/g channel 11
• The transmission may be improved by changing
the transmission channel (frequency) of the other
wireless system(s). For details, refer to the
operating instructions of the other wireless
system(s).
58
GB
Changing the RF output power
(For EZW-T100A wireless transceiver
only)
1
Press AMP MENU.
2
Press V/v repeatedly to select
"S-AIR".
3
Press or b to enter the
menu.
4
Press V/v repeatedly until "RF
POWER" appears in the front
panel display, then press
b.
5
Press V/v to select the desired
setting.
• "HIGH": Normally select this.
• "LOW": The RF output power is
decreased.
6
Press .
The setting is made.
7
Press AMP MENU.
The receiver menu turns off.
or