Sony 4-130-031-11(3) Operating Instructions Manual page 25

Notes
• If "PHONES" appears, you cannot perform the
Auto Calibration. Disconnect the headphones
from the S-AIR product you are using, then restart
the Auto Calibration.
• If "CHK MIC" appears, you cannot perform the
Auto Calibration. Connect the calibration mic,
then restart the Auto Calibration.
Tips
• When Auto Calibration starts:
– Stand some distance from the speakers and the
listening position to avoid measurement failure.
This is because test signals are output from the
speakers during measurement.
– Avoid making noise to get a more accurate
measurement.
• The Auto Calibration function will be canceled
when you do the following during the
measurement process:
– Press ?/1 or
.
– Press input buttons on the remote or INPUT
SELECTOR on the receiver.
– Change the volume level.
Confirming/saving the
measurement results
1
Confirm the measurement
result.
When the measurement ends, a beep
sounds and the measurement result
appears on the display.
Measurement Display
result
When the SAVE
measurement
process
completes
properly
When the ERROR
measurement XXXX
process fails
2
3
When error codes appear
Try the remedies and perform the Auto
Calibration again.
Error code
Explanation
ERROR 32
Proceed to step
2.
See "When
ERROR F 33
error codes
appear" (page
25).
ERROR SR 33 Either the surround left or
Press V/v repeatedly to select
the item. Then, press
Item Explanation
SAVE Saves the measurement
results and exits the setting
process.
WRN CHK Displays warning
concerning the
measurement results. See
"When you select "WRN
CHK"" (page 26).
DIST Displays the measurement
result for speaker distance.
LEVEL Displays the measurement
result for speaker level.
EXIT Exits the setting process
without saving the
measurement results.
Note
After "SAVE" is displayed for 50 seconds, the
measurement result is saved automatically,
without the need to save the procedure.
Save the measurement result.
Select "SAVE" in step 2.
The measurement results are saved.
Cause and remedies
• The sound input from the
optimizer microphone is out of
the acceptable range.
• The optimizer microphone or
subwoofer may be damaged.
Contact your Sony dealer or local
authorized Sony service facility.
The front speakers are not
connected.
Check that the front speakers are
connected properly.
surround right speaker is not
connected.
Check that the surround speakers
are connected properly.
.
continued
25 GB