Table of Contents
Advertisement
Re-pairing the transmitter and the headset
1
Turn on the power of iPod.
(Make sure the iPod is in pause mode.)
2
Connect the transmitter to the iPod (page 16).
3
Place the transmitter and the headset to be paired together
within 1 m (3 ft).
4
Press and hold the POWER button of the headset for about 7
seconds or more to enter "Pairing in process" while the headset
is turned off.
After about 3 seconds, the headset indicator (red) and the
headset indicator (blue) will flash twice, but keep pressing the
POWER button.
Release the POWER button when the headset indicator starts
flashing quickly. The headset enters the pairing process.
5
Press and hold the power button of the transmitter for about 7
seconds or more to enter "Pairing in process."
After about 1 second, the transmitter indicator will flash twice,
but keep pressing the power button.
Notes
When first power on the transmitter after initialized, the transmitter will
enter "Pairing in process" automatically.
The pairing information is initialized if you press and hold the power button
for 15 seconds. The transmitter indicator lights up for 5 seconds before the
initialization starts. Release the button immediately when the transmitter
indicator lights up.
"Pairing in process" is released after about 5 minutes. If pairing is not
established within about 5 minutes, repeat the above procedure from step .
iPod backlight may turn on in this 5 minutes.
To enter "Pairing in process, " you need to turn off the power of the
transmitter first.
2
Advertisement
Table of Contents
