Delay Start Button - Hoover WDXOC 575AC-AUS Manual

PROGRAMME selector with OFF
position
When the programme selector is turned
the display lights up to show the settings
for the programme selected.
For energy saving, at the end of the
cycle or with an inactivity period, the
display level contrast will decrease.
N.B.: To switch the machine off, turn
the programme selector to the OFF
position.
l
Press the START/PAUSE button to start
the selected cycle.
l
Once a programme
programme selector remains stationary on
the selected programme till cycle ends.
l
"End" will appear in the display at the
end of the program and the DOOR
LOCKED light will go off, it is now
possible to open the door.
l
Switch off the washing machine by
turning the selector to OFF.
The programme selector must be
returned to the OFF position at the end
of each cycle or when starting a
subsequent wash cycle prior to the next
programme being selected and started.
START/PAUSE button
Close the door BEFORE selecting the
button START/PAUSE.
l
Press to start the selected cycle.
is selected the
13
When the START/PAUSE button has
been pressed, the appliance can take
few seconds before it starts working.
ADD OR REMOVE ITEMS AFTER THE
PROGRAMMES HAS STARTED (PAUSE)
l
Press and hold the START/PAUSE
button for about 2 seconds (some
indicator light and the time remaining
indicator will flash, showing that the
machine has been paused).
l
Wait until the DOOR LOCKED light has
gone out before opening the door.
Before you open the door, please
check water level is below the door
opening to avoid flooding.
l
After you have added or removed items,
close the door
START/PAUSE button (the programme
will start from where it left off).
CANCELLING THE PROGRAMME
l
To cancel the programme, set the
selector to the OFF position.
l
Wait 2 minutes until the safety device
unlocks the door.

DELAY START button

l
This button allows you to pre-programme
the wash cycle to delay the start of the
cycle for up to 24 hours.
l
To delay the start use the following
procedure:
- Select the required programme.
and press the