Sony PCS-G70 Integration Manual page 21

Menu Page Item
Communication 3/3 Far End Camera Control
Setup
T.120 Data
H.239
*3
4/4 Multipoint Mode
Broadcast Mode
Split
Sender Screen
Status
Audio Setup 1/2 Input Select
Mic Selection
CTE
Echo Canceller
Lip Sync
Recording Mute
2/2 Beep Sound
Sound Effect
Dial Tone
Ringer Tone
*3: Setting is added when H.320 or H.323 MCU Software is installed.
PCS-G70/G70P
Description
Select "On" when controlling camera on the remote party.
Select "Off" when not controlling it.
Select "On" when having data conference conforming to
T.120 using NetMeeting. Select "Off" when not having it.
Select "On" when using dual-video presentation function
conforming to H.239. Select "Off" when not using it.
Select "On" when having multipoint videoconference. Select
"Auto" when switching automatically.
Select "Split" when displaying video of all connected
terminals on the split window. Select "Voice Activate" when
switching video to be distributed by audio detection.
Select "Automatic" to switch between 4-split window (for 1
to 3 terminals) and 6-split window (for 4 to 6 terminals), or
"Six-screen Mosaic" to always display 6-split window.
Select monitor video displayed on sending terminals during
multipoint videoconference.
Display current communication status. ISDN line status,
LAN line status, and LAN communication status are also
displayed according to the line interface used.
Select the audio input (MIC, AUX, or MIC + AUX).
Select microphone to be used (MIC, DSB MIC, or LINE).
Select whether to use the communication transducer
CTE-600 and select input connector to be connected.
Select "Off" when not using CTE-600. Select "LINE" when
inputting to LINE connector of the communication terminal,
and select "DSB AUX IN" when inputting to AUX IN
connector of the data solution box.
n
When CTE-600 is set to be used, "Input Select", "Mic
Select", and "Echo Canceller" are automatically determined
and cannot be changed.
Select "On" when using an echo canceller. Select "Off" when
not using it.
Select "On" when using a lip sync function that synchronizes
the lip motion and voice of a speaker. Select "Off" when not
using it.
Select "On" when outputting audio signal to AUDIO OUT
(MIXED) connector. Select "Off" when not outputting it.
Select "On" to generate beep sound from pressing the
remote commander button. Select "Off" not to generate.
Select "On" to generate effect sound at system start up and
conference start/end. Select "Off" not to generate.
Select "On" to generate ring-back tone or busy tone during
dialing. Select "Off" not to generate.
Select "On" to generate ringer tone with an incoming call.
Select "Off" not to generate
Default
On
Off
On
Auto
Split
Automatic
Full Screen
MIC
MIC
Off
On
Off
On
On
On
On
On
(Continued)
1-17