Test Type And Test Results; Transmitter Parameters; Adaptivity (Adptive Equipment Using Modulations Other Than Fhss) - TP-Link TL-MR6400 Manual

300mbps wireless n 4g lte router
Hide thumbs Also See for TL-MR6400:
Table of Contents

Advertisement

5 Test Type and Test Results

5.1 Transmitter Parameters

5.1.1 Adaptivity (adptive equipment using modulations other than FHSS)

5.1.1.1 Limit
Requirement
Minimum Clear Channel
Assessment (CCA) Time
Maximum Channel
Occupancy (COT) Time
Minimum Idle Period
Extended CCA check
Short Control Signalling
Transmissions
1
Note
: The CCA time used by the equipment shall be declared by the supplier.
Note
2
: Load Based Equipment may implement an LBT based spectrum sharing mechanism based
on the Clear Channel Assessment (CCA) mode using energy detect, as described in IEEE
802.11™-2012 [i.3] clause 9, clause 10, clause 16, clause 17, clause 19 and clause 20, or in IEEE
802.15.4™-2011 [i.4], clause 4, clause 5 and clause 8.
Note
3
: Adaptive equipment may or may not have Short Control Signaling Transmissions.
Interference threshold level:
Maximum transmit power (P
Note
1
: TL = -70 dBm/MHz + 10 × log10 (100 mW / Pout)
Note
2
: transmitter the CCA threshold level (TL) shall be equal or lower than -70 dBm/MHz at
the input to the receiver (assuming a 0 dBi receive antenna).
Unwanted Signal parameters
Wanted signal mean power
from companion device
sufficient to maintain the link
(see Note
Note
1
: The highest frequency shall be used for testing operating channels within the range
2400 MHz to 2442 MHz, while the lowest frequency shall be used for testing operating channels
Non-LBT
based
Detect and
Avoid
NA
18 us (see Note
40 ms
1 ms to 10 ms
5% of COT
NA
Maximum duty cycle of 10 % within an observation period of 50 ms
)
H
EIRP dBm
20
Unwanted signal
frequency
2 395 or 2 488,5
2
)
(see Note
Operational Mode
LBT based Detect and Avoid
Load Based
Frame Based
Equipment
Equipment
(CCA using
'energy detect')
1
)
(see Note
(see Note
5% of COT
(see Note
NA
(see Note
(see Note
Threshold level (TL)
(Pout in mW e.i.r.p.).
(MHz)
1
)
12 / 25
Report No.: BL-SZ1770154-601
Load Based
Equipment
(CCA not using any
of the mechanisms
referenced asNote
2
)
18 us (see Note
2
)
13 ms
2
)
NA
a random duration in
the range between
2
)
18 μs and at least
160 μs
3
)
-70 dBm / MHz
Unwanted CW signal
power (dBm)
-35
(see Note
3
)
2
)
1
)

Advertisement

Table of Contents
loading

Table of Contents