Installing And Connecting - Binatone Oval Twin XD1220 Instruction Manual

Oval XD1200 model:
1. Handset - 1 pcs.
2. Base unit - 1 pcs.
3. AC adapter – 1 pcs
4. Phone line cord - 1 pcs.
5. AAA type rechargeable battery – 3 pcs.
6. Battery compartment cover – 1 pcs.
Oval Twin XD1200 model:
1. Handset - 2 pcs.
2. Base unit - 1 pcs.
3. Battery charger – 1 pcs.
4. AC adapter – 2 pcs
5. Phone line cord – 1 pcs.
6. AAA type rechargeable battery – 6 pcs.
7. Battery compartment cover – 2 pcs.
1. Connect one end of the phone line cord [24] to the phone line jack [22] on the base
unit [12], and the other – to the phone line socket.
2. Insert the AC adapter [23] cable plug into its jack [21] on the base unit [12]. Insert
the AC adapter [23] cable plug into the wall socket of your electric mains (220V AC).
3. Insert the AC adapter [23] cable plug into its jack [26] on the charger [23], insert the
AC adapter [21] cable plug into the wall socket of your electric mains (220V AC).
4. Install the battery [18] into its compartment [19] in the handset [1], close the
compartment [19] with the battery compartment cover [20].
5. Place the handset [1] on the base unit [12] and on the charger [25]. Before the
first use you should fully charge the battery, so let the battery charge
for 10 hours.
:
1. When charging an almost discharged battery, at first the charging process is the
most intensive, after that the intensity of the process decreases to a slow recharging.
During the first stage the handset becomes warm, this is normal and not dangerous.
The handset will return to normal temperature during the process of slow charging.
2. For maximum distance and noise free operation, place the base unit in a high and
central location far away from electric appliances, such as refrigerator's, PC's, TV
set's, or other telephones".
The Oval series handset will not operate without an external power supply from
your electrical network. Therefore, to make an emergency call in case of power failure,
you will have to use another telephone that does not need an external power supply.
In your package
INSTALLING AND
CONNECTING