Nokia 7360 Intelligent Services Access Manager FX Series Hardware Installation Manual page 63

ANSI Hardware Installation Manual
6
7
Procedure 7
1
2
3
4
5
6
7
8
Issue: 09
Cut open the moisture vapor bag with the shears and remove packing or bracing material.
STOP. This procedure is complete.
To inspect equipment
Check the equipment items against the packing list.
Is the equipment packed in a container or a box?
a If in a container, go to step 3.
b If in a box, go to step 6.
Before removing the equipment from the container, check inside the container for parts that
may have become loose during shipment, and remove them.
Danger — Possibility of personal injury. Lifting heavy equipment
without the appropriate tools for material handling could result in physical
harm and/or damage the equipment. When lifting the racks, apply
appropriate pulleys or hoists and use the eye bolts.
Remove the equipment from the container, then raise the rack to a vertical position.
Remove the two transport brackets and eye bolts from the rack. Secure the rack to keep it
from falling over.
Check the equipment parts against the packing list.
Inspect the equipment for damage. The exterior and interior of equipment and component
parts must be free from grease, dirt, and corrosion.
Warning — Do not install damaged or dirty equipment, since this can
adversely affect the equipment.
If anything is missing or damaged, notify the transportation carrier and Nokia immediately.
Photograph all damaged equipment. Keep all inspection and packing documents for
reference.
3HH-12893-AAAA-TCZZA
DRAFT
Installing racks
63