Connections For A Cut Editing System - Sony DSR-1800AP Operating Instructions Manual

Connections for a Cut Editing System

The following figure shows a cut editing system
configuration that includes two DSR-1800A/1800AP units
to serve as the player and recorder.
When you select assemble or insert editing mode on
the editing control unit, the two DSR-1800A/1800AP
units (recorder and player) will automatically enter the
selected editing mode.
DSR-1800A/ DSR-1800A/
1800AP (player) 1800AP (player)
VIDEO
OUT 2
(SUPER)
1
Composite
video input
Source monitor
Settings on the DSR-1800A/1800APs (recorder
and player)
Button Recorder
REMOTE On (lit)
9PIN On (lit)
For details of the video/audio input and audio mode
settings for the recorder, see "Settings for Recording" on
page 31.
1
SDI OUT
AUDIO
REMOTE
MONITOR
OUT
3 2 1
Audio input
PLAYER
Editing control unit (PVE-500, etc.)
Player
On (lit)
On (lit)
When using a VCR other than the DSR-1800A/1800AP,
refer to its instruction manual.
A 75 Ω coaxial cable (not supplied)
B 9-pin remote control cable
(not supplied)
C Cable with RCA phono plugs
(not supplied)
REF.
VIDEO
OUT
VIDEO
OUT 2
(SUPER)
1
Composite
video input
REF.
VIDEO IN
Main monitor
RECORDER
a)
a) For the settings on the editing control unit, see
"Settings on an editing control unit" on page
90.
About reference video signals
In order to provide stable video and audio signals for
analog editing, it is necessary for the built-in time base
corrector (TBC) to operate correctly. To ensure this, input
a reference video signal synchronized with the video signal
to the REF. VIDEO IN connector.
DSR-1800A/
SDI IN
1800AP (recorder)
AUDIO
REMOTE
MONITOR
OUT
3 2
Audio input
Connections for a Cut Editing System
85