Sony DSR-1800AP Operating Instructions Manual page 22

A Analog video signal input/output section
ANALOG VIDEO
VIDEO IN
a VIDEO IN connectors
a VIDEO IN connectors (BNC type)
Input an analog composite video signal. This connector
block has a built-in automatic 75 Ω termination switch.
When a signal is input to the left VIDEO IN connector
with no bridging (loop-through) connection made, the
connector is terminated with an impedance of 75 Ω
automatically. To connect the signal input to the left
VIDEO IN connector also to other equipment, use the right
VIDEO IN connector (marked
VIDEO IN connector is used, the built-in 75 Ω termination
switch turns off automatically.
b S VIDEO IN connector (4-pin)
Input an S-video signal with separated Y (luminance) and
C (chroma: 3.58 MHz for DSR-1800A or 4.43 MHz for
DSR-1800AP) components to this connector.
22
Location and Function of Parts
S VIDEO COMPONENT VIDEO IN
IN Y R-Y
B-Y
c COMPONENT VIDEO IN Y/R
b S VIDEO IN connector
COMPONENT VIDEO OUT
VIDEO OUT S VIDEO
2
OUT Y
f S VIDEO OUT connector
). When the right
REF.VIDEO
VIDEO OUT
IN OUT 1
(SUPER)
e VIDEO OUT 1 and 2 (SUPER)
connectors
d REF. VIDEO IN/OUT connectors
− −
Y/B Y connectors
TIME CODE
R-Y
IN OUT
B-Y
h TIME CODE IN/OUT connectors
g COMPONENT VIDEO OUT Y/R
c COMPONENT VIDEO IN Y/R−Y/B−Y connectors
(BNC type)
Input analog component video signals (Y/R−Y/B−Y) to
these connectors.
d REF. (reference) VIDEO IN/OUT connectors
(BNC type)
Input a reference video signal. The IN connector block has
a built-in automatic 75 Ω termination switch. When a
signal is input to the left REF. VIDEO IN connector with
no bridging (loop-through) connection made, the
connector is terminated with an impedance of 75 Ω
automatically. To connect the reference video signal input
to the left REF. VIDEO IN connector also to other
equipment, use the right REF. VIDEO IN connector
(marked ). When the right REF. VIDEO IN connector
S VIDEO
2 OUT Y
− −
Y/B Y connectors