Baldor DBSC105-AAA-1 Installation And Operating Manual page 7

Section
WARNING: Do not remove cover for at least five (5) minutes after AC
power is disconnected to allow capacitors to discharge.
Dangerous voltages are present inside the equipment.
Electrical shock can cause serious or fatal injury.
WARNING: Improper operation of control may cause violent motion of
the motor shaft and driven equipment. Be certain that
unexpected motor shaft movement will not cause injury to
personnel or damage to equipment. Peak torque of
several times the rated motor torque can occur during
control failure.
WARNING: Motor circuit may have high voltage present whenever AC
power is applied, even when motor is not rotating.
Electrical shock can cause serious or fatal injury.
Caution: To prevent equipment damage, be certain that the
electrical service is not capable of delivering more than
the maximum line short circuit current amperes listed in
this manual.
Caution: To prevent equipment damage, be certain that the input
power has correctly sized protective devices installed as
well as a power disconnect.
Caution: To prevent equipment damage, DO NOT connect a 24VDC
source to terminal strip X2 if the 24 Volt option is not
installed. If you apply 24VDC to X2 without the option, the
control will be damaged.
1–4 MN1229