Table of Contents
Advertisement
10
TROUBLESHOOTING
If you have difficulty with your phone, please try the suggestions listed below.
Problem
No dialling tone when pressing the
<TALK> key
When connected to a PBX, no and/or
wrong connection after dialling.
"OUT OF RANGE" is displayed.
The call does not work.
No display.
Please contact the technical support of the network provider for further
information.
This telephone is not equipped with an earth function! Therefore some of
the functions may be limited when used in PBX systems.
If the fault persists:
Disconnect all other instruments connected to the same line as this, and try
to make a call.
Disconnect the base unit from the telephone line and plug a different phone
into the master socket. Try making a call. If this works the line is ok.
If the call does not work, and you are using a two-way socket adapter,
remove it and plug the telephone directly into the socket. If the call now
works, the adapter may be faulty.
Cause
a. The connection cord of the base
station is not plugged in.
b. The adapter cord is not plugged in
correctly in the base station.
c. The line is busy, as another
handset is used.
d. Wrong telephone line cord.
Dialling prefix is needed.
a. Base station out of range.
b. Base station not connected to
mains.
Service not activated or wrong
operator or wrong setting
Empty battery
32
Solutions
a. Check the connections. Unplug
and plug back in the mains.
Check that the telephone line cord
has been plugged into the base
station and the phone socket.
b. Check the base station plug and
the 230V plug (remove and plug-in).
c. Wait until the line is unoccupied.
d. Use the original telephone line cord
supplied.
Insert the dialling prefix
Reduce the range.
Connect base station to mains.
Check your Subscription with network
or change the dial mode.
Recharge battery
m
Hide quick links:
Advertisement
Table of Contents
