Registration - Binatone SPEAKEASY COMBO 2005 TRIPLE User Manual

9

REGISTRATION

IMPORTANT: When you purchase your phone system, all handsets are
already registered to your base, so you do not need to register them.
Handset registration is only necessary when you buy extra handsets or if a
handset has become faulty.
You can register additional handsets to have up to five handsets per base
unit, with each handset's number (1 to 5) shown on its display.
(Note: each handset can only be registered to one base.)
To check whether a handset is registered, make sure mains power to the
base unit is switched on and the handset is within range. The handset's
display should show its number and the <Antenna icon> should be steadily
on. If the display shows "REGISTER", you need to register the
handset again using the following process:
On the cordless handset:
1. Press <MENU/OK> and <UP/DOWN> to select REGISTRATION.
2. Press <MENU/OK> to display "
the base (default PIN code is 0000).
3. Press <MENU/OK> and the display will flash
On the base:
4. At the same time, press and hold the <FIND> key for about 5 seconds
or until it beeps, to indicate the base is in registration mode.
5.
A confirmation beep is played to indicate successful registration, and
the handset returns to idle mode with its handset number displayed and
the antenna icon steady.
If registration fails, the handset beeps and the display returns to show
REGISTER and the antenna icon continues to flash.
PIN ?", enter the 4-digit PIN code for
"PLEASE WAIT".
31