Hardware Installation
1. Ensure that the computer in use has an Ethernet
Controller port (RJ-45 Ethernet Port). For more
information, verify with your computer's user manual.
2. Connect one end of the Category 5e Ethernet cable
into the RJ-45 port of the EWS550AP/EWS510AP/
EWS511AP and the other end to the RJ-45 port of the
computer. Ensure that the cable is securely connected
to both the EWS550AP/EWS510AP/EWS511AP and the
computer.
3. Connect the Power Adapter DC connector to the DC-IN
port of the EWS550AP/EWS510AP/EWS511AP and the
Power Adapter to an available electrical outlet. Once
both connections are secure, verify the following:
a) Ensure that the POWER light is on (it will be orange).
b) Ensure that the 2.4 GHz/5 GHz WLAN light is on (it will
be blue for 2.4G, and green for 5G).
c) EnsuregthatgthehLANg(ComputergEWS55OAPgConnection)
light is on (it will be blue).
d) Once all three lights are on, proceed to set up the
Access Point using the computer.
This diagram depicts the hardware configuration.
PC
24
Ethernet
AC/DC
Cable
Power
Outlet