Specifying manual operation sensor values
By specifying the sensor values, you can test the function of the tunnel application. By
double-clicking on a box for the sensors, you access the automatic / manual operating mode.
In the example, the following was set for tunnel section 1:
● Manual operation for setting the CO limit value (air quality sensor)
● CO limit value of 28
● Manual operation for specifying the limit value for the vision (turbidity sensor)
● Value for the vision of 2
Figure 3-10
S7-1500R/H redundant system
Getting Started, 10/2018, A5E44910930-AA
Specifying HMI screen sensor values
Programming
47