Controlling Your Tv Or Av Receiver (Amplifier) With The Supplied Remote - Sony DVP-S360 Operating Instructions (CD/DVD Component) Operating Instructions Manual

x DTS
Selects the DTS signals to be output via the DIGITAL OUT
OPTICAL and COAXIAL connectors. You cannot select
this item when you set "DIGITAL OUT" to "OFF."
• OFF: when the player is connected to an audio
component lacking a built-in DTS decoder.
• ON: when the player is connected to an audio
component having a built-in DTS decoder.
If the player is connected to an audio component
lacking a built-in DTS decoder, do not set this.
Otherwise, when you play the DTS sound track, a loud
noise will come out from the speakers, affecting your
ears or causing the speakers to be damaged.
Note
Select the setting correctly. Otherwise, no sound or a strange
sound will come out from the speakers, affecting your ears or
causing the speakers to be damaged.
Controlling your TV or AV
Receiver (Amplifier) with
the Supplied Remote Z
If you adjust the remote signal, you can control your TV
or AV receiver (amplifier) with the supplied remote.
Default setting is to control Sony TVs with the
1 2
Number buttons
4 5
7 8
0
Controlling TVs or AV receivers
(amplifiers) with the remote
Hold down TV @/1, and enter your TV's or AV
receiver's manufacturer's code (see the table) using the
number buttons. Then release TV @/1.
Code numbers of controllable TVs or
AV receivers (amplifiers)
If more than one code number is listed, try entering them
one at a time until you find the one that works with your
TV or AV receiver (amplifier).
Notes
• If you enter a new code number, the code number previously
entered will be erased.
• When you replace the batteries of the remote commander, the
code number reset to 01 (Sony). Reset the appropriate code
number.
mark.
TV @/1
3
6
9
53