5.1 Channel Surround Hookups - Sony DVP-S335 Operating Instructions Manual

5.1 Channel Surround Hookups

With DVDs which contain DTS, Dolby Digital or MPEG
AUDIO sound, you can enjoy the surround sound while
producing the effect of being in a movie theater or a
concert hall using a digital component with a built-in
DTS, Dolby Digital or MPEG decoder (not supplied). The
player outputs the surround sound signals from the
DIGITAL OUT OPTICAL and COAXIAL connectors.
Using a receiver (amplifier) having the OPTICAL or
COAXIAL connector and 6 speakers, you can enjoy even
greater real audio presence in the comfort of your own
home.
Note
When a DVD has a sound track with 7.1 channels recorded in
MPEG AUDIO format, the output audio signals are mixed down
to 5.1 channels.
Required cords
Optical digital connecting cord* (not supplied) (1)
Coaxial digital connecting cord* (not supplied) (1)
S video cord (not supplied) (1)
* Connect the component via the DIGITAL OUT OPTICAL or
COAXIAL connector using an optical or coaxial digital
connecting cord (not supplied). You do not need to connect
both of these cords. See the figure on the next page.
Notes
• Do not connect the power cord to an AC outlet or press the
POWER switch before completing all connections.
• Refer to the instructions supplied with the component to be
connected.
• The cord connectors should be fully inserted into the jacks.
Loose connection may cause hum and noise.
14
Setups for the player
Some setup adjustments are necessary for the player
depending on the components to be connected.
Use the setup display to change the various settings.
For details on using the setup display, see page 46.
• When you connect an audio component with a built-
in Dolby Digital decoder A
Set "DIGITAL OUT" in "AUDIO SETUP" to "ON" and
then set "DOLBY DIGITAL" to "DOLBY DIGITAL" in
the setup display. (page 56)
• When you connect an audio component with a built-
in MPEG decoder B
Set "DIGITAL OUT" in "AUDIO SETUP" to "ON" and
then set "MPEG" to "MPEG" in the setup display. (page
56)
• When you connect an audio component with a built-
in DTS decoder C
Set "DIGITAL OUT" in "AUDIO SETUP" to "ON" and
then set "DTS" to "ON" in the setup display. (page 56)
AUDIO SETUP
AUDIO ATT:
AUDIO DRC:
DOWNMIX: DOLBY SURROUND
DIGITAL OUT:
DOLBY DIGITAL:
MPEG:
DTS:
To set, press , then ENTER
To quit, press .
DISPLAY
Notes
• When you do not connect an audio component with a
built-in Dolby Digital decoder , do not set "DOLBY DIGIT AL"
to "DOLBY DIGIT AL."
• When you do not connect an audio component with a
built-in MPEG decoder , do not set "MPEG" to "MPEG."
• When you do not connect an audio component with a
built-in DTS decoder , do not set "DTS" to "ON."
OFF
STANDARD
ON
DOLBY DIGITAL
MPEG
ON
.