Startup Procedures; Introduction; Ws Controller Panel Layout - Sullair 02250160-842 Instruction Manual

2.

STARTUP PROCEDURES

2.1

INTRODUCTION

This compressor is equipped with an WS Controller for controlling the compressor
system operation, setting the machine parameters and performing maintenance
operations. The WS Controller is designed for the safe operation and protection of the
compressor system. When fault conditions occur, the controller automatically shuts down
the machine before the conditions can cause damage to the equipment.
Controller also contains features that enable sequential interface with other machines.
2.2

WS CONTROLLER PANEL LAYOUT

The WS Controller panel is shown in Figure 2.1. The controller panel consists of :
Display Screen for displaying machine status
•
START
•
STOP
•
while the machine is stopped
UP arrow and DOWN
•
displays and for changing parameter values
ENTER
•
values
Machine status indicator lights for identifying the current machine operational status.
•
Each of the controller components and functions is described in detail in Section 4.
Figure 2.1 WS Controller Panel
START
PAD
STOP
PAD
UP ARROW
PAD
FAULT
INDICATOR
(RED)
pad for machine startup
pad for stopping machine operation and for clearing fault messages
arrow pads for navigation through the various panel
pad for selecting and accessing various screen displays and for entering
MAINTENANCE
INDICATOR
(AMBER)
STARTUP PROCEDURES
AUTO MODE
DOWN
INDICATOR
ARROW
(GREEN)
PAD
Section 2
The WS
DISPLAY
SCREEN
ENTER
PAD
POWER ON
INDICATOR
(GREEN)
5