Surround Mode Settings - Sony DVP-NS975V Operating Instructions Manual

Checking the audio signal
format
You can check the audio signal format by
pressing AUDIO repeatedly during playback.
The format of the current audio signal (Dolby
Digital, DTS, PCM, etc.) appears as shown
below.
Example:
Dolby Digital 5.1 ch
Rear (L/R)
1 : ENGLISH DOLBY DIGITAL
Front (L/R)
+ Center
Example:
Dolby Digital 3 ch
Front (L/R)
2 : SPANISH DOLBY DIGITAL
About audio signals
Audio signals recorded in a disc contain the
sound elements (channels) shown below.
Each channel is output from a separate
speaker.
• Front (L)
• Front (R)
• Center
• Rear (L)
• Rear (R)
• Rear (Monaural): This signal can be either
the Dolby Surround Sound processed
signals or the Dolby Digital sound's
monaural rear audio signals.
• LFE (Low Frequency Effect) signal
54
LFE (Low
Frequency Effect)
3 / 2 .1
L C R
LFE
LS RS
Currently playing
programm format
Rear (Monaural)
2 / 1
L R
S
Currently playing
programm format

Surround Mode Settings

You can enjoy surround sounds while playing
discs including Dolby Digital and DTS
DVDs, even if you have only 2 or 4 speakers.
Select the surround mode that best suits your
speaker setup.
1
Press SUR during playback.
The following display appears.
TVS DYNAMIC
2
Press SUR repeatedly to select
one of the surround modes.
See the explanations given for each item
in the following section.
For 2 speaker setups
(If you select a setting other than
"NONE" in the setting of "REAR" in
"SPEAKER SETUP" (page 85), you
cannot select these modes.)
• TVS DYNAMIC
• TVS WIDE
• TVS NIGHT
• TVS STANDARD
SUR