Table of Contents
Advertisement
Suunto D5
4. Care and support
4.1. Handling guidelines
Handle Suunto D5 with care. The sensitive internal electronic components may be damaged if
the device is dropped or otherwise mishandled.
When travelling with this dive computer, ensure that it is packed securely in check-in or carry-
on luggage. It should be placed in a bag or other container where it cannot move around
bumped or easily hit.
Do not try to open or repair Suunto D5 by yourself. If you are experiencing problems with the
device, please contact your nearest authorized Suunto Service Center.
WARNING: ENSURE THE WATER RESISTANCE OF THE DEVICE! Moisture inside the
device and/or battery compartment may seriously damage the unit. Only an authorized
Suunto Service Center should do service activities.
Wash and dry the dive computer after use. Rinse very carefully after any salt-water dive.
Pay special attention to the pressure sensor area, water contacts, pushers, and USB cable
port. If you use the USB cable before washing the dive computer, the cable (device end)
should be rinsed as well.
After use, rinse it with fresh water, mild soap, and carefully clean the housing with a moist soft
cloth or chamois.
NOTE: Do not leave your Suunto D5 in a bucket of water (for rinsing). The display stays
on under water and consumes battery life.
Use only original Suunto accessories - damage caused by non-original accessories is not
covered by warranty.
WARNING: Do not use compressed air or high pressure water hoses to clean your dive
computer. These can permanently damage the pressure sensor in your dive computer.
TIP: Remember to register your Suunto D5 at www.suunto.com/support to get
personalized support.
4.2. Installing scratch guard
Use the provided scratch guard to help protect your Suunto D5 from scratches.
To install the scratch guard:
1. Ensure the display glass is clean and dry.
2. Peel back the protective layer from one end of the scratch guard.
3. Place exposed adhesive side down squarely on one end of the display.
4. Pull back the protective layer from the scratch guard.
5. Press out any air bubbles with a soft, straight edge tool.
Watch the video on : YouTube.
32
Advertisement
Table of Contents
