Settings For The Sound (Audio Setup) - Sony DVP-NS315 Marketing Operating Instructions Manual

Settings for the Sound
(AUDIO SETUP)
"AUDIO SETUP" allows you to set the sound
according to the playback and connection
conditions.
Select "AUDIO SETUP" in the Setup
Display. To use the display, see "Using the
Setup Display" (page 57).
The default settings are underlined.
AUDIO SETUP
AUDIO ATT:
AUDIO DRC:
DOWNMIX:
DIGITAL OUT:
DOLBY DIGITAL:
DTS:
AUDIO ATT (attenuation)
If the playback sound is distorted, set this
item to "ON." The player reduces the audio
output level.
This function affects the output of the LINE
OUT L/R (AUDIO) jacks.
OFF
Normally, select this position.
ON
Select this when the playback sound
from the speakers is distorted.
AUDIO DRC (Dynamic Range Control)
(DVD only)
Makes the sound clear when the volume is
turned down when playing a DVD that
conforms to "AUDIO DRC." This affects the
output from the following jacks:
– LINE OUT L/R (AUDIO) jacks
– DIGITAL OUT (OPTICAL or COAXIAL)
jack only when "DOLBY DIGITAL" is set
to "D-PCM" (page 62).
STANDARD Normally select this position.
TV MODE
Makes the low sounds clear
even if you turn the volume
down.
WIDE Gives you the feeling of being
RANGE
at a live performance.
Switches the method for mixing down to 2
channels when you play a DVD which has
rear sound elements (channels) or is recorded
in Dolby Digital format. For details on the
rear signal components, see "Checking the
audio signal format" (page 43). This function
affects the output of the following jacks:
– LINE OUT L/R (AUDIO) jacks
– DIGITAL OUT (OPTICAL or COAXIAL)
DOLBY
SUR-
ROUND
OFF
STANDARD
DOLBY SURROUND
ON
NORMAL
D-PCM
OFF
Selects if audio signals are output via the
DIGITAL OUT (OPTICAL or COAXIAL)
jack.
ON
OFF
DOWNMIX (DVD only)
jack when "DOLBY DIGITAL" is set to
"D-PCM" (page 62).
Select this when the player is
connected to an audio
component that conforms to
Dolby Surround (Pro Logic).
Select this when the player is
connected to an audio
component that does not
conform to Dolby Surround (Pro
Logic).
DIGITAL OUT
Normally select this position. When
you select "ON," see "Setting the
digital output signal" for further
settings.
The influence of the digital circuit
upon the analog circuit is minimal.
61
,continued