(Cdm-7857Rb Only); Turning Loudness On/Off; Adjusting Source Signal Levels; Adjusting Volume/Bass/Treble/Balance (Between Left And Right)/Fader (Between Front And Rear) - Alpine CDM-7857RB Owner's Manual

Non Fading Pre-Out (N.F.P.) On
and Off (CDM-7857RB only)
Use the N.F.P. On mode when a non-fading
signal would be most effective. For example, to
drive an amplifier with a low-pass filter for the
subwoofer.
1
Press and hold the Eject (c) button for at least 3
seconds with the unit turned on.
With each press, N.F.P. is toggled On or Off.
N.F.P. ON:
In this position, the Front Pre-Output will not be
affected by the fader. This is ideal for driving a
subwoofer amplifier.
N.F.P. OFF:
Returns to normal fader mode.
NOTES
• Initial mode is "N.F.P. OFF."
• Set the N.F.P. to OFF unless the subwoofer is used.

Turning Loudness On/Off

Loudness introduces a special low- and high-
frequency emphasis at low listening levels. This
compensates for the ear's decreased sensitivity
to bass and treble sound.
1
Press and hold the LOUD button for at least
2 seconds to activate or deactivate the loudness
mode. The display shows "LOUD" when the
loudness mode is activated.

Adjusting Source Signal Levels

If the difference in volume level between the CD
player and FM radio is too great, adjust the FM
signal level as follows.
1
Press and hold the INTLZ button for at least 3
seconds.
2
Press the Preset 1 button to select the FM signal
level HI (High) or LO (Low) to make the signal
levels between the FM band and CD player
closer.
3
Press the INTLZ button to cancel the adjusting
mode.
Adjusting Volume/Bass/Treble/
Balance (Between Left and Right)/
Fader (Between Front and Rear)
1
Press the MODE button repeatedly to choose
the desired mode.
Each press changes the modes as follows:
→ VOL → BAS
FAD ←
NOTE
If the 5 or 6 button is not pressed in 5 seconds after
selecting the BASS, TREBLE, BALANCE and FADER
modes, the unit automatically sets in the VOLUME
mode.
2
Press the 5 and 6 buttons until the desired
sound is obtained in each mode.
NOTE
The BASS and TREBLE settings for each source (FM,
MW (LW) and CD) will be automatically memorized
whenever the settings are changed.
→TRE
BAL ←
5
-EN
FR
ES
DE
IT
SE