6 - 14
Removing and installing the UCM Board
Recommended tools: Phillips screwdriver
To remove the UCM board from the main board
(See Figure 9 and Figure 10)
1. Remove the main board from the display & chassis assembly. Refer to
2. Open the UCM fastening screw.
3. Turn the Main Board over.
4. Gently remove the UCM Board from the Main Board. Verify not to damage
MTH800 TETRA Handportable Terminal / Basic Service Manual
"Removing and Installing the Main Board" on page 11.
Please note that the UCM-M module does not have a fastening screw.
the UCM connector when removing the board.
UCM BOARD
MAIN BOARD
Figure 10 UCM Board Removal and Installation
UCM
CONNECTOR
MAINTENANCE