Removing And Installing The Back Housing; To Remove The Back Housing From The Unit - Motorola TETRA MTH800 Basic Service Manual

MAINTENANCE
1. Slide the tooth-shaped tip into location.
2. Snap the tip into location.

Removing and Installing the Back Housing

Recommended tools: T-8 Torx bit, Torx driver, mini flat-tip screwdriver

To remove the back housing from the unit

(See Figure 7)
1. Remove the antenna.
2. Remove the battery door and the battery.
3. Place the unit facing down on the clean work area.
4. Using the screwdriver remove the oval label at the top of the unit (Logo label)
5. Using the Torx driver with the T-8 Torx bit, unscrew the six screws fastening
6. Carefully remove the back housing from the unit.
MTH800 TETRA Handportable Terminal / Basic Service Manual
Figure 6 Audio Assembly Cap Removal and Installation
and the Tamper Evident label to gain access to all six screws fastening the
back housing. Clean the adhesive remains of the labels using alcohol.
the back housing. Remove the six washers.
1. Slide
2. Snap
6 - 9