Checking The Play Information - Sony DVP-K360 Operating Instructions Manual

Sony operating instructions cd/dvd player dvp-k360
Table of Contents

Advertisement

TV Virtual Surround Sound Settings (TVS)
TVS (TV Virtual Surround) STANDARD
Uses sound imaging to create virtual rear speakers from
the sound of the front speakers (L, R) without using actual
rear speakers. The virtual speakers are reproduced as
shown in the illustration below. Use this setting when you
want to use TVS with 2 separate speakers and retain the
sound quality.
L
L: Left front speaker
R: Right front speaker
: Virtual speakers
Notes
• When you select an effect, the sound cuts off for a moment.
• When the playing signal does not contain a signal for the rear
speakers (page 32), the surround effects may be difficult to
hear.
• When you select one of the TVS modes, turn off the surround
setting of the connected TV or amplifier (receiver).
• Make sure that your listening position is between and at an
equal distance from your speakers, and that the speakers are
located in similar surroundings. Otherwise, the TVS effect may
be hard to discern.
• TVS NIGHT only works with Dolby Digital and MPEG audio
discs. However, not all discs will respond to the TVS NIGHT
function in the same way.
• If you use the DIGITAL OUT OPTICAL or COAXIAL connector
and set "DOLBY DIGITAL" to "DOLBY DIGITAL" in "AUDIO
SETUP," sound will come from your speakers but it will not
have the TVS effect.
• Do not use the TVS function together with the KARAOKE
SURROUND function (page 49). You will not be able to enjoy
the surround sound effect presented by TVS.
36
R
Checking the Play
Information
You can check information such as the bit rate or the disc
layer that is being played.
While playing a disc, the approximate bit rate of the
playback picture is always displayed as Mbps (Mega bit
per second) and the audio as kbps (kilo bit per second).
Select "ADVANCED" after pressing DISPLAY.
1 2 ( 2 7 )
1 8 ( 3 4 )
T
1 : 3 2 : 5 5
BIT RATE
ADVANCED
Select:
x ADVANCED
The default setting is underlined.
When playing a DVD
• OFF: turns off ADVANCED display.
• BIT RATE: displays the bit rate.
• LAYER: displays the layer and the pick-up point.
PLAY
DVD
BIT RATE
kbps
1000
0
Mbps
0
5
10
ENTER

Advertisement

Table of Contents
loading

Table of Contents