Sony DVP-K360 Operating Instructions Manual page 11

Notes
• You cannot enjoy a picture with an S video signal if your TV
does not conform to the S video signal. When your TV does
not have an S VIDEO input, connect the component via the
LINE OUT VIDEO connector using the video connecting cord
(not supplied) instead of the S video cord. For details, see page
8.
Refer to the instructions supplied with your TV.
• Refer to the instructions supplied with the component to be
connected.
• You cannot make digital audio recordings of discs recorded in
multichannel surround format directly using an MD deck or
DAT deck.
• If you select one of the TVS settings (page 35) while playing a
DVD, the player does not output the following signals from the
DIGITAL OUT (COAXIAL and OPTICAL) jacks.
– Dolby Digital signals (when you set "DOLBY DIGITAL" in
"AUDIO SETUP" to "D-PCM")
– MPEG audio signals
Setups for the player
Some setup adjustments are necessary for the player
depending on the components to be connected.
If you run Quick Setup (page 14), you can make the
minimum number of basic adjustments to the player.
When you connect a receiver (amplifier) which
has a digital connector and lacks a built-in DTS,
Dolby Digital or MPEG audio decoder, or a digital
component such as a DAT or MD deck
The "AUDIO SETUP" (page 65) items in the setup display
must be set as shown in the illustration below.
These are the default settings and do not need to be
adjusted when you first connect the player.
Refer to page 56 for displaying the "AUDIO SETUP"
menu.
AUDIO SETUP
AUDIO ATT:
AUDIO DRC:
DOWNMIX:
DOLBY SURROUND
DIGITAL OUT:
DOLBY DIGITAL:
MPEG:
DTS:
To set, press , then
ENTER
To quit, press .
DISPLAY
OFF
STANDARD
ON
D-PCM
Set the
PCM
items as
OFF
shown
.
11