Utilize Existing Acpu Data; Replace Ad75(P/M) With Qd75(P/D/M/Mh) While Utilizing Existing Positioning Parameters And Data - Mitsubishi Electric Artisan MELSEC-Q Series Manual

General-purpose programmable controllers, large/small

Table of Contents

Utilize existing ACPU data

8.1 Replace AD75(P/M) with QD75(P/D/M/MH) while utilizing existing positioning

parameters and data

Solution and Benefit

• Existing positioning parameters and data of the AD75(P (-S3)/M ) can be used for the QD75(P /

D /M /MH ) with minimal modifications, reducing upgrade time.

• Although the AD75(P (-S3)/M ) and QD75(P /D /M /MH ) may have different addresses even in

the same setting item, mistakes can be prevented because parameters and data can be used

without having to worry about buffer memory address.

The following is an example of replacing an existing A (Large Type) positioning module with the Q Series while

utilizing existing parameters and data.

● Instructions

After replacing the A (Large Type) modules with the Q Series, reuse/convert positioning parameters and data

of the AD75 using GX Configurator software package for positioning modules.

Software packages to be used are as follows:

• For AD75 models: GX Configurator-AP Version 1 (SW D5C-AD75P-E)

• For QD75 models: GX Configurator-QP Version 2 (SW D5C-QD75P-E)

(1) System configuration example

Current configuration

*Utilize existing positioning parameters and data when replacing.

Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com

After replacement

Replace

158

Table of Contents