Booting The Board From Sd Card - Intel Quark SoC X1000 User Manual

Booting the board from SD card

12 Booting the board from SD card
To boot your board from an SD card and enable persistent rootfs, follow these steps.
You can also use this procedure to boot your board from a USB stick.
If you are using an Intel
sketch to the board, so it will be able to repeat sketches after board power-down. This
also enables a persistent /sketch folder and rootfs.
Dependencies:


1. The output of the build process in
2. Insert the SD card, then power on the board.
Note: The first time you boot the board may take several minutes. This is expected behavior
due to the SSH component creating cryptographic keys on the first boot.
Order Number: 329687-007US
Galileo board, this setup allows you to save your Arduino*
®
You ran the command bitbake image-full in
(or bitbake image-full-galileo if using an Intel
Your SD card must meet the following requirements:
 SD card must be formatted as FAT or FAT32.
 SD card size must be 32GB (or smaller) and SDHC format.
SDXC format is not supported.
Copy the following kernel and root file system files to an SD card:

boot (directory)

bzImage

core-image-minimal-initramfs-clanton.cpio.gz
 image-full-clanton.ext3 or
image-full-galileo-clanton.ext3 for the Intel
Be sure to set up your SD card with the files and structure shown below.
Section 6
® Galileo board)
Section 6 is found in ./tmp/deploy/images/
® Galileo board
BSP Build and Software User Guide
Intel ® Quark™ SoC X1000
29