Removing The Console-Method A - Whirlpool Cabrio WTW8500DW Technical Education

WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or
electrical shock.
Removing the Console—Method A
The new sleek contoured design of the User Interface makes
access of the console a bit of a challenge. Since the console is
recessed into the top panel (see Figure 1), the usual method
of sliding a tool under the console to release the clips can be a
bit tricky.
Console Assembly
Modify the Putty Knife
A putty knife can work, but it should be plastic and modified
as shown in Figure 2 so that it can be maneuvered around the
screw, which is placed directly in front of the release clips.
2¾
"
½
"
Removing the Console—Method A
New recessed
console design
Top Panel
Figure 1
Figure 2
1. Unplug washer or disconnect power.
2. Turn off water supply to washer.
3. Remove two (2) 1/4" hex-head mounting screws from the
rear of the console as indicated in Figure 3.
4. Slide the putty knife down between the console assembly
and top panel. Use your free hand to push back on the
top of the console while you flex and maneuver the putty
knife up and around the screw. (See Figures 4 & 5).
5. Depress the console clip with the putty knife and lift up on
the console to separate from top panel (see Figure 5). Tilt
the console forward for service.
Shock Mount Screw
Whirlpool 2014 CABRIO
COMPONENT ACCESS
Figure 3
Figure 4
Console Clip
Figure 5
Direct Drive Washer
®
4-3
n