Removing The Console - Whirlpool Maytag MVW6200KW Technical Manual

WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.
1. Unplug washer or disconnect power.
2. Turn off the water supply to the washer.
3. Remove two (2) 1/4" (6 mm) hex-head/TORX
of the console.
4. Raise the Lid.
5. While pushing back and up on the console, slide thin plastic putty knife
(or thin plastic cake knife) between the console and Top Panel.
†®Torx is a registered trademark of Acument Intellectual Properties, LLC.
DO NOT REMOVE OR DESTROY
FOR SERVICE TECHNICIAN'S USE ONLY

Removing the Console

T20 screws from the rear
†
Push back and
up on the console
6. Depress the console clip by pushing straight back with the putty knife
while lifting the console to separate from the Top Panel.
7. Close the lid.
8. Tilt console forward to access.
31