Terminal Cover - Makita MAKSTAR DC18RA Technical Information

R
epair
[1] DISASSEMBLY/ASSEMBLY

[1] -2. Terminal Cover

DISASSEMBLING
1. Separate charger case cover from charger case complete. (Fig. 1)
2. Remove PT3x10 tapping screw and disassemble terminal cover.
<Note> Be sure to hold two compression springs with your finger so as not to jump out of terminal cover
when disassembling terminal cover.
ASSEMBLING
1. While setting two 4 compression springs in terminal cover and aligning them with the bosses of charger case
complete, fit the rib of terminal cover to that of charger case complete. (Fig. 4.)
2. Fasten PT3x10 tapping screw through elliptic hole of charger case complete into the screw hole of terminal
cover. (Refer to Fig. 4.)
3. Make sure that terminal cover can return to the original position by the help of compression spring 4, after
pushing terminal cover toward the charging position.
< Note >
Compression Spring 4 is used also as a cushion for terminal unit as illustrated in Fig. 3. However, this compression
spring 4 is different from those for terminal cover in the free length and coil diameter. (Fig. 5A)
Fig. 5
Rib of Terminal
Cover
Here is boss for accepting
compression spring 4.
Fig. 4
Terminal Cover
Charger Case Cover
Compression Spring 4
Here is boss for accepting
compression spring 4.
Rib of Charger
Case Complete
Compression Spring 4
Tapping Screw
PT3x10
Fig. 5A
Pt. No.233194-8
Compression spring 4 for Terminal Cover
*L (Free Length) : 25mm
*D (Coil Diameter): 4.8mm
Pt. No.231474-6
Compression spring 4 for Terminal Unit
*L (Free Length) : 20mm
*D (Coil Diameter): 5.0mm
D
P 3 / 5
L