Sony FCB-PV480 Technical Manual page 12

Digital Image Output Modes
Three kinds of digital image output modes are
available. Also, 30 fps and 25 fps modes are available
for each of these digital image output modes. In total,
six digital image output modes are supported.
I/F mode Output SYNC
16bit YUV HSYNC/
Progressive VSYNC
16-bit 4:2:2
8bit YUV HSYNC/
Progressive VSYNC
8-bit 4:2:2 SAV/EAV
8bit Interlace YUV HSYNC/
Scan VSYNC
8-bit 4:2:2 SAV/EAV
Mode set at the factory : 16-bit PS, 29.97 fps
Selecting digital image output modes
• The S501 switch of the FCB camera allows you to
change the output mode between 16-bit and 8-bit
output modes.
• The new VISCA command allows you to select either
PS mode or IS mode.
Selecting frame rate
New VISCA commands allow you to select either
29.97 (p) or 25.0 (p) mode.
Either 59.94 (i) or 50.0 (i) is available for Interlace.
Others
E-FLIP
This function turns the video output from the camera
upside down.
Mirror Image
This function reverses the video output from the
camera horizontally.
Freeze
This function captures an image in the field memory of
the camera so that this image can be output
continuously.
Because communication inside the camera is based on V
cycle, the captured image is always the one 3V to 4Vs after
the sending of a Command. Thus, you can not specify a time
period after sending a Command.
Frame rate Clock
29.97 fps / 13.5 MHz
25.0 fps
29.97 fps / 27.0 MHz
25.0 fps
29.97 fps / 27.0 MHz
25.0 fps
Memory (Position Preset)
Using the position preset function, 6 sets of camera
shooting conditions can be stored and recalled.
This function allows you to achieve the desired status
instantly even without adjusting the following items
each time:
• Zoom Position
• Digital Zoom On/Off
• Focus Auto/Manual
• Focus Position
• AE Mode
• Shutter control parameters
• Bright Control
• Iris control parameters
• Gain control parameters
• Exposure Compensation On/Off
• Exposure Level
• Backlight Compensation On/Off
• Slow Shutter Auto/Manual
• White Balance Mode
• R/B Gain
• Aperture
• ICR Shoot On/Off
Custom Preset
As with the position preset function, the camera
shooting conditions can be stored and recalled. The
settings are recalled when the power is turned on.
For setting items, see the "Initial Settings, Custom Preset
and Backup" section on page 32.
User Memory Area
A user area of 16 bytes allows you to write data, such
as an ID for each customer, data for each system, and
so on, freely.
Note
Rewriting of memory is not unlimited. Be careful to avoid using
the memory area for such as unnecessary tasks as rewriting the
contents of the memory for every operation.
Privacy Zone Settings
For details, see page 14.
Alarm
For details, see page 18.
Basic Functions
12