Valet Parking Mode; Accessing The Menu For The Valet Parking Mode - BMW X5 Owner's Manual

ConnectedDrive countries: If the driver profile
was synchronized with a ConnectedDrive ac‐
count, the stored data in the ConnectedDrive ac‐
count will be retained.
System limits
A clear detection of the desired remote control
may not be possible in the following cases, for
example:
▷ The driver unlocks the vehicle via Comfort
Access and has multiple remote controls with
him or her.
▷ The driver changes, but the vehicle is not
locked and unlocked.
▷ When multiple remote controls are located
outside on the driver's side of the vehicle.
If the remote control was not detected clearly,
unlock the vehicle by pressing button for the de‐
sired remote control.
ConnectedDrive countries:
A driver profile can only be created and
synchronized with the ConnectedDrive account
when cellular reception is available.
The use of personal settings that are stored in
the ConnectedDrive account in other vehicles is
subject to technical limitations. For example, set‐
tings may be stored for a system that is not avail‐
able, or available in a non-compatible version, in
other vehicles.

Valet parking mode

Concept
In the valet parking mode, the Control Display is
locked and operation via iDrive is no longer pos‐
sible.
For example, this mode can be used when the
vehicle is handed over for valet parking.
General information
In the valet parking mode, it is not possible to
change vehicle settings via iDrive. Personal set‐
Opening and closing
Online Edition for Part no. 01402896765 - X/18
tings cannot be changed and personal settings
cannot be displayed.
Additionally, the following actions are carried out:
▷ The volume of the audio system is limited.
▷ The integrated remote control is deactivated.
▷ DSC cannot be switched off.
▷ The tailgate can be locked and disconnected
from the central locking system.
Functional requirements
▷ At least one driver profile has been created.
▷ A driver profile or the guest profile is active.
▷ At least one driver profile has an assigned
ConnectedDrive account.
Accessing the menu for the valet
parking mode
Via the switch-off screen
After switching off drive-ready state the switch-
off screen will be displayed. Select the entry for
the valet parking mode on the switch-off screen.
Via the display bar at the upper edge
of the Control Display
1. Tip the Controller up
2. "Valet parking mode"
Via the vehicle settings
Via iDrive:
1. "CAR"
2. "Settings"
3. "General settings"
4. "Valet parking mode"
CONTROLS
101