Use The Prosafe Plus Utility To Specify Lag Membership; And Enable Lags - NETGEAR PROSAFE XS716E User Manual

8-Port or 16-Port 10-Gigabit/Multi-Gigabit Smart Managed Plus Switch
7. Select the ports for the LAG by selecting the associated check boxes under the port
numbers.
A LAG consists of at least two ports.
8. Click the Apply button.
Your settings are saved.
9. Select System > LAG > LAG Configuration.
10. Select the ID of the LAG for which you just set up the port membership.
11. In the Admin Mode menu, select Enable.
12. Click the Apply button.
Your settings are saved.

Use the ProSAFE Plus Utility to specify LAG membership

and enable LAGs

You must set up LAG membership before you can enable LAGs.
To specify LAG membership and enable a LAG:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired network connection, or connect directly to a switch that is
off-network using an Ethernet cable.
2. Double-click the ProSAFE Plus Utility icon.
The Switch Selection page displays a list of Web Managed switches that it discovers on
the local network.
3. Select the switch.
If you do not see the switch, click the REFRESH button.
4. Click the APPLY button.
You are asked to enter the password for the switch.
5. Enter the switch's password in the password field.
The switch's default password is password.
Network Settings 36 User Manual