Troubleshooting - Sony DSC-FX77 Operating Instructions Manual

Troubleshooting

If you have trouble with your camera, try
the following solutions.
Sending/Printing images
Symptom
The Bluetooth button
does not work.
[SEND] or [PRINT] in the
Bluetooth menu cannot be
selected.
The desired Bluetooth
device cannot be
discovered.
20
For details on your VAIO, refer to the
HELP of the VAIO or the following
URL: http://www.sony-imaging.com/
support/
Cause
• The MODE dial is not set to
• The playback zoom function is being used.
• The MODE dial is not set to
• No "Memory Stick" is inserted.
• No images are in the selected folder.
• A movie or Clip Motion file is selected.
• The device is not turned on.
• The device is not connectable.
• The device ran past the time limit.
• The device is placed outside of radio wave range
• The antenna portion of your camera or the
device is covered with your hand etc.
• The desired device is now connecting to another
device.
• The name of the device has been changed.
• More than 10 Bluetooth devices are found
around your camera.
• The name of the device is not found.
Solution
p Set the MODE dial to
.
p Cancel the playback zoom function (see the operating
instructions).
. p Set the MODE dial to
p Insert a "Memory Stick" (see the operating instructions).
p Select the folder where the image is stored (see the operating
instructions).
p Select an image file other than Movie or Clip Motion files.
p Turn on the device. For details, see the operating instructions
supplied with the device.
p Check that the Bluetooth function of the device is started up and
the device is connectable.
p Set the device so that it is connectable and perform a new search
(page 7).
p Move the device closer to your camera.
p Do not cover the antenna portion (page 4).
p Wait until the connection is finished and perform a new search
(page 7).
p Check the name of the device.
p The maximum number of devices discoverable using a new
search is 10. The order in which devices are discovered depends
on existing conditions. Turn off all devices except the desired
device, or repeat new searches until the desired device is found.
p When a new search is canceled, the name of the device you are
searching for may not be found. A substitute name (e.g.,
Device1) may be displayed instead. Identify the device address
and type (page 35) and select it again or perform the new search
again.
(see the operating instructions).
(see the operating instructions).