Sony Cyber-shot DSC-F77A Operating Instructions Manual page 10

Charging the battery pack (continued)
Battery life and the number of
images that can be recorded/
viewed
The tables show approximate guidelines for
the length of time the camera can be used
when you shoot in Normal mode in an
environment where the ambient
temperature is 25°C (77°F), and the
supplied battery pack is fully charged. The
guidelines for the number of images that
can be recorded or viewed allow for
changing the "Memory Stick" as necessary.
Actual results may differ slightly from
these, depending on the conditions of use.
Shooting still images
1)
In normal shooting
NP-FC11 (supplied)
No. of
Image size images
2272×1704 Approx. 170
1) Shooting at 30-second intervals with [P.
QUALITY] set to [FINE], LCD screen turned
on, flashed every two shootings and turned on/
off every ten shootings.
10
Viewing still images
Image size
2272×1704
640×480
2) Playing back images in order at about 3-second
intervals on the single-image screen.
Shooting movies
NP-FC11 (supplied)
LCD screen ON
(min.)
Approx. 90 min
3) Continuous shooting with an image size of
160×112
Battery life
• The battery life and the number of images
(min.)
recordable or playable are decreased under the
Approx. 85
following conditions:
– At low temperature.
– Using the flash.
– Turning on and off frequently.
– When [LCD BACKLIGHT] is set to
[BRIGHT]
– When [POWER SAVE] is set to [OFF].
– Using the battery pack that was used
repeatedly or the battery capacity decreases
as time passed (page 102).
2)
NP-FC11 (supplied)
No. of Battery life
images (min.)
Approx. 3800 Approx. 190
Approx. 3800 Approx. 190
3)
LCD screen OFF
(min.)
Approx. 120 min
The POWER SAVE function
When the POWER SAVE function is
activated, you can shoot for a longer period
of time.
Set the MODE dial to SET UP, and set
[POWER SAVE] in (SETUP 1) to
[ON]. The factory setting is [ON] (page 99).
• The [POWER SAVE] item is only shown when
using the battery pack.
When the POWER SAVE function is
activated
• The LCD screen will be darker than it is when
[POWER SAVE] is set to [OFF]. You cannot
change the settings for [LCD BACKLIGHT] at
this time (page 99).
• When shooting sill images, the focus works
only while the shutter button is pressed down
halfway.