Service Schedule; Maintenance Log - Generac Power Systems G0065510 Owner's Manual

Maintenance

Service Schedule

Service
Inspect enclosure louvers for dirt and debris *
Inspect lines and connections for fuel or oil leaks
Inspect engine oil level
Check for water intrusion **
Perform fuel system leak test
Check battery condition, electrolyte level, and state
of charge
Replace engine oil and oil filter †
Replace engine air filter
Clean; inspect spark plug gap; replace if necessary
Inspect/adjust valve clearance ‡
Inspect/clean sediment trap
Contact the nearest IASD for assistance if necessary.
* Remove any shrubs or tall grasses which have grown within 3 ft (0.91 m) of intake and discharge louvers on enclosure sides. Clean any debris (dirt, grass
clippings, etc.) which may have accumulated inside the enclosure.
** Verify all sources of potential water intrusion such as water sprinklers, roof run-off, rain gutter downspouts, and sump pump discharges are directed away from
generator enclosure.
† Change engine oil and filter after the first 25 hours of operation. In cold weather conditions (ambient below 40 °F [4.4 °C]), or if unit is operated continuously in hot
weather conditions (ambient above 85 °F [29.4 °C]), change engine oil and filter every year or 100 hours of operation.
‡ Check/adjust valve clearance after the first 25 hours of operation.
NOTE: Contact an IASD or visit

Maintenance Log

Battery Inspection and Charge Check
Dates Performed:
Oil, Oil Filter, Air Filter, and Spark Plug Replacement
Dates Performed:
Valve Adjustment
Dates Performed:
26
Daily If Running Continuously
or Before Each Use
●
●
●
www.generac.com for additional information on replacement parts.
Schedule A
Every
Every Two Years
Year
or 200 Hours
●
●
● ●
●
Consult local codes and guidelines.
Owner's Manual for 60 Hz Air-Cooled Generators
Schedule B
Every Four Years
or 400 Hours
●
●
●
●
●