Sony Wega KE-P37XS1 Operating Instructions Manual page 46

Problem
Stripe noise during playback/recording
of a VCR.
Poor or no picture (screen is dark), but
good sound.
Noisy picture when viewing a TV
channel.
Distorted picture when changing
programmes or selecting teletext.
In the screen appears an image retention
(afterimage)
The screen flickers when turning on the
TV.
Wrong characters appear when viewing
teletext.
Wrong characters appear when viewing
NexTView.
No sound/Noisy sound.
Good picture, no sound.
Audio noise.
46
Additional Information
Possible solution
• Video head interference. Keep your VCR away from the TV.
• Leave a space of 30 cm between your VCR and the TV set to avoid
noise.
• Avoid installing your VCR in front or at the side of the TV set.
• Using the menu system, select the "Picture Adjustment" menu and
select "Reset" to return to the factory settings (page 19).
• If the PICTURE OFF indicator lights up in blue, press
(picture off) on the remote control.
• Using the menu system, select the "Manual Programme Preset"
option in the "Set Up" menu and adjust Fine Tuning (AFT) to
obtain better picture reception (page 28).
• Using the menu system, set the "Noise Reduction" option in the
"Picture Adjustment" menu to reduce the noise in the picture (page
19).
• Turn off any equipment connected to the Scart connector on the rear
of the TV set.
• Using the menu system, select the "Features" menu, next select the
"Screen Saver" submenu and finally set the "All White" option to
"On" to reduce the image retention (see page 24).
• This is inherent in the Plasma Display Panel, and does not indicate
a malfunction.
• Using the menu system, enter the "Country" option in the "Set Up"
menu and select the country in which you operate the TV set (page
26). For Cyrillic languages, we recommend that you select Russia
if your own country does not appear in the list.
• Using the menu system, enter the "Language" option in the "Set
Up" menu and select the language as the NexTView is broadcasted
(page 37).
• Press the 2 + on the remote control.
• Check that "TV Speakers" option is set to "Main" in the "Sound
Adjustment" menu (page 21).
• Make sure that the aerial is connected using the supplied coaxial
cable.
• Keep the aerial cable away from other connecting cords.
• Do not use 300-ohm twin lead cables as interference may occur.
• Communication problems may occur if the infrared communication
equipment (e.g. infrared cordless headphones) is used near the TV.
Please use headphones other than infrared cordless headphones,
move the infrared transceiver away from the TV until the noise is
eliminated, or move the transmitter and receiver of the infrared
communication equipment closer together.
continued...