Power-button assembly
Removing the power-button assembly
Prerequisites
1
Follow the procedure in
2
Remove the
base
cover.
3
Remove the
2230 solid-state
4
Remove the
2280 solid-state
5
Remove the
rear
I/O-cover.
6
Remove the battery.
7
Remove the
left
I/O-board.
8
Remove the
right
I/O-board.
9
Remove the
system
board.
About this task
The following image indicates the location of the power-button assembly and provides a visual representation of the removal
procedure.
Steps
1
Remove the three (M2x1.9) screws that secure the power-button bracket to the palm-rest assembly.
2
Lift the power-button bracket off the power-button assembly.
3
Peel the power-button assembly and its cable off the palm-rest assembly.
Installing the power-button assembly
Prerequisite
If you are replacing a component, remove the existing component before performing the installation procedure.
52
Before working inside your
drive. (if applicable)
drive. (if applicable)
computer.