Boss Dr.Sample SP-202 Owner's Manual page 36

36
3.
Press the REC button.
The REC button will light, and loading will begin. While
this button is lit, do not
tum
the power off or remove the
card from the slot.
When loading has been finished, the REC button will go
dark.
2.
Press a pad to specify the card area that you wish
to load into internal memory.
The pad you pressed will blink.
If
you decide to cancel the Load operation, press the
CANCEL button.
1. Hold down CANCEL and press the BANK INT
A/B button.
The REC button will blink, and pads corresponding to
card areas which contain data will light.
Load
When this operation
is
performed, the internal data of
the SP-202 will be overwritten. Be sure to make a backup
of important data before you do this.
*
A set of data (16 samples) that was saved to a memory card
can be re-loaded into internal memory in a single operation.
I
Loading data from a
memory card {Load)
In some cases, a SmartMedia card which was used by the
SP-202 may no longer be usable by other SmartMedia-
compatible devices.
*
3.
Press the REC button.
The REC button will light, and the Save process will
begin. While this button is lit, do not tum the power off
or remove the card from the slot.
When saving has been finished, the REC button will go
dark.
In the case of a card to which you are saving data for the
first time, it will only be possible to select I, and pad 1
will blink when you press it.
For the second and subsequent Save operations to a card,
the pads will light to indicate the corresponding areas
which contain data. At this time, data can be saved to the
areas which correspond to pads which are lit (overwrite)
and the pad immediately following the lit pads (the new
save destination). When you press one of these pads, it
will blink.
If
you decide to cancel the Save operation, press the
CANCEL button.
2.
Press a pad to specify the number of the area into
which you wish to save the data.
The pad that you pressed will blink.
1. Hold down the CANCEL button, and press the
BANK CARD
ao
button.
The REC button will blink.
!:ill!IOBB
er, -
-
Ii@\ a
El
a
i~j
:~@@@\~
t --
Internal memory
' . J
8
L=-ll=.l!=l~l - 11
!!j
~~~~EJ
~~~~EJJ
A set of the 16 samples in banks A/B of the SP-202's internal
memory can be saved (backed up) to a backup area on a
memory card.
Data that has been saved in this way cannot be played back
until it is once again loaded into the SP-202.
I
Saving to a memory card
{Save)