AEG LB1360 User Manual page 25

• - The appliance does not drain the water.
• - The appliance lid is open or not closed correctly. Please check the lid!
13.2 Possible failures
Problem
The programme does
not start.
The appliance does not
fill with water properly.
The appliance fills with
water and drains immedi-
ately
The appliance does not
drain the water.
The spin phase does not
operate or the washing
cycle lasts longer than
usual.
Possible solution
• Make sure that the mains plug is connected to the mains
socket.
• Make sure that the appliance lid and drum door are closed.
• Make sure that there is no damaged fuse in the fuse box.
• Make sure that the Start/Pause
• If the delay start is set, cancel the setting or wait for the end
of countdown.
• Deactivate the Child Lock function if it is on.
• Check the position of the knob on the selected pro-
gramme.
• Make sure that the water tap is open.
• Make sure that the pressure of the water supply is not too
low. For this information, contact your local water authority.
• Make sure that the water tap is not clogged.
• This problem may be caused by the filter of the inlet hose
or by the clogged drain circuit. Please contact the Author-
ised Service Centre.
• Make sure that the filter of the inlet hose and the filter of
the valve are not clogged. Refer to 'Care and cleaning'.
• Make sure that the drain hose is in the correct position. The
hose may be positioned too low. Refer to "Installation in-
struction".
• Make sure that the sink spigot is not clogged.
• Make sure that the drain hose has no kinks or bends.
• This problem may be caused by the clogged drain circuit.
Please contact the Authorised Service Centre.
• Make sure that the connection of the drain hose is correct.
• Set the drain programme if you set a programme without
drain phase.
• Set the drain programme if you set an option which ends
with water in the tub.
• Set the spin programme.
• This problem may be caused by the clogged drain circuit.
Please contact the Authorised Service Centre.
• Adjust manually the items in the tub and start the spin
phase again. This problem may be caused by balance prob-
lems.
ENGLISH
has been touched.
25