Troubleshooting - AEG LB1360 User Manual

24 www.aeg.com
Programmes
Delicates 40°C
Wool 30°C
Standard cotton programmes
Standard 60°C cotton
Standard 60°C cotton
Standard 40°C cotton
1) At the end of spin phase.
The information given in the chart above is compliant with the EU Commission regulation
1015/2010 implementing directive 2009/125/EC .

13. TROUBLESHOOTING

WARNING!
Refer to Safety chapters.
13.1 Introduction
The appliance does not start or it stops during operation.
First try to find a solution to the problem (refer to the table). If the problem persists,
contact the Authorised Service Centre.
WARNING!
Deactivate the appliance before carrying out any check.
In case of major problems, the acoustic signals operate, the display shows an
alarm code and the Start/Pause
• - The mains supply is unstable. Wait until the mains supply is stable.
• - No communication between electronic elements of the appliance. Switch it
off and switch on again. The programme was not finished properly or the appliance
stopped too early. If the alarm code appears again, contact the Authorised Service
Centre.
• - The appliance does not fill with water properly. After the proper check, start
the appliance again by pressing Start/Pause
resume the cycle . If the error persists the alarm code will appear again.
Load
(kg)
2,5
1
7
3,5
3,5
Off Mode (W)
0.48
Energy Water
consump- consump-
tion (kWh) tion (litre)
0,55 46
0,35 50
0,97 43
0,65 37
0,60 38
Left On Mode (W)
button may flash continuously:
button the appliance tries to
Approxi- Remain-
mate pro- ing mois-
gramme
ture (%)
duration
(minutes)
90 35
65 30
260 53
190 53
190 53
0.48
1)