Dell Latitude 5300 Service Manual page 81

4 Remove the battery.
Steps
1 Peel the adhesive tape and disconnect the cable from the connector on the system board [1].
2 Remove the single (M2x4) screw that secures the eDP cable bracket to the system board [2].
3 Lift the eDP cable bracket from the system board [3].
4 Disconnect and unroute the eDP cable [4].
5 Open the display assembly to a 180-degree angle and flip over the system, and then place the system on a flat surface.
Disassembly and reassembly 81