Table of Contents
Advertisement
BIOS Setup
▶ Super IO Configuration (the Carrier Board)
▶ Serial Port 1, Serial Port 2
This setting enables/disables the specified serial port.
▶ Change Settings
This setting is used to change the address & IRQ settings of the specified
serial port.
▶ Mode Select
Select an operation mode for the serial port 1/ 2.
▶ Parallel Port
This setting enables/disables the parallel port.
▶ Change Settings
This setting is used to change the address & IRQ settings of the parallel
port.
▶ Device Mode
Select an operation mode for the parallel port.
▶ FIFO Mode
This setting controls the FIFO data transfer mode.
▶ Shared IRQ Mode
This setting provides the system with the ability to share interrupts among its
serial ports.
▶ Watch Dog Timer
You can enable the system watch-dog timer, a hardware timer that generates
a reset when the software that it monitors does not respond as expected each
time the watch dog polls it.
3-8
Advertisement
Table of Contents
