Installing The Ifp Basic; Notes On Installation - Siemens SIMATIC IFP Basic Series Operating Instructions Manual

3.2

Installing the IFP Basic

3.2.1

Notes on installation

Before installing the device, please ensure that the installation location complies with the
following:
Risk of fire
The device is classified as "OPEN EQUIPMENT" for use in the area of industrial control
equipment in accordance with UL61010-2-201. In the event of overheating, the device may
discharge burning materials that can cause a fire.
Keep in mind:
• The installation of the device in an enclosure conforming to UL61010-2-201 is a
Note
If the equipment is used in an manner not specified by the manufacture, the protection
provided by the equipment might be impaired.
● Ensure that the protective contact socket of the building installation is easily accessible
and that there is a mains disconnect switch in switchgear cabinet installations.
● Position the device so that it is not exposed to direct sunlight.
● Position the device so that it is easily accessible for the operator.
● Choose a suitable installation height.
● Ensure that the air vents of the device are not covered as a result of installation. Note the
permitted mounting positions.
IFP Basic
Operating Instructions, 03/2019, A5E46178354 - AB
WARNING
mandatory requirement for approval and operation in accordance with UL61010-2-201.
Installing and connecting the device
3.2 Installing the IFP Basic
25